homeProductsPressureGauge>Plastic case PG

Plastic case PGPCtypepdf Opened by the PDF form

  1. ABSresin was adopted for the case and making to a low cost was measured.
  2. It is the best for the place where rust like the water surroundings etc. for which the sealed type doesn't need sealing up is generated easily.

Example of order※When the mouse is put, the explanation is displayed.

PC A M _ G3/8 × 100 × 2.5 S1・ E1・

Please quote the sign from the following table.

Plastic case PG

※Please confirm it suits "Condition of use" and "Adjusting pressure medium" to obtain the performance enough safely when you select the pressure gauge.

Type PC
Size 50 60 75 100
External shape A D4 A B
Additional
specification
(each usage)
Common type(sign none) Common type for steam(sign M)
Vibration-proof type(sign V) Vibration-proof type for steam(sign MV)
Accuracy class <Standard>2.5 <Specification>1.6 1.6 <Standard>1.6 <Specification>1.0
(1)Connected screw G・R1/4 G・R3/8
(2)
Maximum
scale
value
(MPa)
Pressure
Gauge
0.06 0.1 0.16 0.25 0.4 0.6 1 1.6 2.5 4 6 10 16 25 40 60 100
(Excluded size60、75)
Vacuum meter -0.1
Manifold type <Pressure part>0.1 0.16 0.25 0.4 0.6 1 1.6 2.5  <Vacuum part>-0.1
M
a
t
e
r
i
a
l
Liq
uid
Medium
varieties
<Standard> For general
<Specification> For steam and heatproof <Specification> For anti-corrosion
Stock C3604 C3604 SUS316
Bourdon tube <Low pressure>C2700、C5191<High pressure>C5191、SUS316 SUS316 SUS316
Machine
on inside
<Standard> Copper base alloy <Specification> SUS(Excluded size50)
Case (3)ABSresin・Black <Specification>Simple sealing up(sign W1)
Ring ABSresin・Black
Lamina lucida <Standard>Inorganic glass board <Specification>Polycarbonate board(sign P7)
Scale plate AI Display color・・・Pressure part:Black ・ Vacuum part:Red
Indicator AI <Specification>0 point adjustment needle(Size75、100)
Additiona
specification
(special)
(4)Throttle screw(SignF1) Oil processing(SignE1) Clean processing(SignE2)
Gasleak Test(SignE3) (5)Installation needle:Label type(SignF5)、Switch type(SignF7)
(6)Scale color paint(SignF8) (7)Document attachment(SignT1)

□Remarks

  1. Please inquire when assuming it to other screw necessity.
  2. Please inquire when you need other maximum scale values.
  3. It doesn't become a sealed structure. Please tell us for the necessity the sealed structure.
  4. As for squeezing Throttle screw, the difference is in the buffering effect because of the viscosity and the flow velocity etc. of the fluid though the diameter is StandardФ0.5. Please see other throttles and see "Throttle screw" for the necessity.
  5. Please see "Installation needle" here for details of Installation needle.
  6. Please specify the range of the color paint scale and the color for Scale color paint.
  7. Please direct the inspection report, the mill sheet, the standard machine inspection result book, the inspection points book, and the traceability system chart, etc.
Copyright (C) 2009 Takashimakeiki. All Rights Reserved.